• 

  Stack Mold Injection Molding Process Parameter Settings

  Stack mold, also known as double‑layer or tandem mold, is an efficient production solution that enables simultaneous injection molding in two upper and lower layers within one mold. Its production cap

  2026/02/14 Injection Molds

• 

  Injection Production Mold Change Efficiency Improvement Skills

  In injection workshop production, mold change time directly determines equipment utilization, order delivery speed and production cost. Especially in the multi‑variety and small‑batch production mode,

  2026/02/14 Plastic Molds

• 

  Practical Guide to In‑Mold Decoration (IMD) Process

  In-Mold Decoration (IMD) is an advanced surface decoration process that places pre-printed films into injection molds and forms integrally through injection molding, allowing plastic and films to bond

  2026/02/12 Injection Molds

• 

  Maintenance of Plastic Mold Hot Runner Systems (Supplement)

  Hot runner systems are key components of high-efficiency, high-precision injection molds, widely used in mass production of plastic products. They improve production efficiency, reduce material waste,

  2026/02/11 Plastic Mold

• Operation Steps for Screw Cleaning in Injection Molding Production

  Screw cleaning is an essential operation before material/color changes, production transfer, and shutdown maintenance in injection molding. Residues (old material, carbon, color powder, glass fiber) i

  2026/02/11 Injection Molding

• Guide to Mold Steel Selection for Low-Temperature Injection Molding

  Low-temperature injection molding, with mold temperatures controlled at room temperature to 40℃ (even 0℃～20℃ for cooling-sensitive materials), is widely used in precision engineering plastics, transpa

  2026/02/10 Injection Molding

• Solutions to Flash on the Parting Surface of Plastic Molds

  In plastic mold production, flash on the parting surface is a common problem affecting product appearance and efficiency. It increases flash trimming time, reduces yield, and even causes mold crushing

  2026/02/10 Plastic Molds

• Practical Skills for Eliminating Injection Molding Weld Lines

  In injection molding production, weld lines are one of the most common defects affecting product appearance and strength, especially obvious in transparent parts, appearance parts and structural parts

  2026/02/10 Injection Molding