• Differences Between Injection Mold Opening and 3D Printed Prototypes and Phase Selection Suggestions

  In the iterative development of plastic products, 3D printed prototypes and injection mold opening are the two core methods for sample verification and mass production landing. Most enterprises are pr

  2026/09/07 Plastic Molds

• Factors Affecting Plastic Mold Design Fees

  Plastic mold design is the core link in the early stage of mold development. The rationality of the design scheme directly determines the later processing difficulty, molding stability and mold modifi

  2026/09/07 Plastic Mold

• Differences in Hygiene Standards Between Food‑Grade Injection Molds and Conventional Molds

  Food‑grade injection molds manufacture plastic parts that directly contact food. Mold material, surface condition and maintenance mode will influence food‑contact safety of finished products. Conventi

  2026/09/04 Injection Mold

• Mold Carbon Deposit Cleaning and Prevention Measures for Flame‑Retardant ABS Production

  Flame‑retardant ABS contains halogen or halogen‑free flame‑retardant additives. Under continuous high‑temperature shear conditions, additives tend to decompose. Small‑molecule precipitates adhere to m

  2026/09/04 Injection Molding

• Difficulties in Mold Opening and Molding Solutions for Plastic Parts with Complex Structures

  With the popularization of lightweight, integrated and special‑shaped product design, more plastic parts feature deep cavities, thin walls, multiple undercuts, dense ribs, large height differences and

  2026/09/04 Injection Molding

• Specification Selection and Application‑Scenario Analysis of Pipe Plugs for China Plastic Molds

  Plastic pipe plugs are widely used for mold cooling water channels, hydraulic pipelines, metal pipes and equipment housings to seal port ends, prevent water and oil leakage, block dust and rust, and p

  2026/09/04 China Plastic Molds

• Distinction and Treatment Solutions for Gas Bubbles and Vacuum Voids in Injection‑Molded Plastic Parts

  Internal cavities are common defects for injection‑molded plastic products. Gas bubbles and vacuum voids look similar in appearance but differ completely in root causes, occurrence positions and corre

  2026/09/04 Injection Molds

• Key Points for Selecting Plastic Mold Suppliers in China

  The comprehensive capability of plastic mold suppliers directly affects mold‑opening cost, delivery cycle, molded‑part quality, as well as the efficiency of later‑stage mold modification and after‑sal

  2026/09/03 Chinese Plastic Mold Supplier